Recently i had to recompile for the Creality* Ender 3v2 (not NEO!) a new Klipper firmware based off the Klipper 0.11.
As per the instructions of the installation of Klipper you will have to flash the microcontroller as follows:
|
|
During “make menuconfig” select the following settings:
- Enable extra low-level configuration options
- Micro-controller Architecture (STMicroelectronics STM32)
- Processor model (STM32F103)
- Bootloader offset: (28KiB bootloader)
- Communication Interface: (Serial (on USART1 PA10/PA9))
Once you have compiled the firmware using make
you can flash it by copying the file out/klipper.bin
to a SD card and turning on the printer with the card inserted. The firmware filename must end in “.bin” and must not match the last filename that was flashed.